The energy that will take you to the horizon and beyond...

SmartSolar MPPT RS charge controllers are Victron solutions for large series-connected PV array systems charging 48V DC battery arrays. This product is ideal for large on-grid or off-grid battery systems.

Models available in 5.76 kW and 11.52 kW; features include a wide solar input voltage range operating on 80-450 VDC, independent tracker inputs, full connectivity, isolated PV connections, display screen, fully programmable charging parameters and a active cooling. The new metal chassis design and fully covered electrical connections improve safety and modernize the presentation in line with the latest series of Victron products.

Features
Solar charge controller with ultra-fast maximum power point tracking (MPPT)
The SmartSolar MPPT RS is a 48V solar charge controller with up to 450VDC PV input, and 100A or 200A output. maximum battery charge.
Multiple independent MPPT tracking inputs
With multiple MPPT trackers, you can optimize your solar panel design for maximum yield at your specific location.
Isolated PV connections for added safety
Full galvanic isolation between PV and battery connections provides additional safety to the entire system.
Wide MPPT voltage range
80-450 VDC PV operating range with 120 VDC PV start voltage.
Lightweight, efficient and quiet

Thanks to high-frequency technology and a new design, this powerful charger weighs only 7.9 kg for the 100 A model. In addition, it features excellent efficiency, low standby power consumption and very quiet operation.

screen and Bluetooth
The screen reads the battery and controller parameters. The same settings are accessible from a smartphone or a device with an activated Bluetooth function. Additionally, the Bluetooth function can also be used to configure the system and change settings using VictronConnect.

PV insulation resistance monitoring for peace of mind at higher voltages
The MPPT RS continuously monitors the PV array, and it can detect if there are any failures that reduce panel insulation to a dangerously safe level.

VE.Can and VE.Direct port
Connect to a GX device for system monitoring, data logging, and remote firmware updates. VE.Can makes it possible to connect up to 25 units in parallel and synchronize their load.

I/O connections
Connections for programmable relay, temperature probe, auxiliary digital input, and voltage probe. The remote input is compatible with Victron's smallBMS as well as other types of BMS that have a 'Authorize-to-Charge' signal.

Victron offers you a full range of cutting-edge products that can meet your expectations. Each of them can be adapted to your specific needs.